Hello,
Could you please clarify your intended end goal a bit further? Specifically, do you want to forward VPN traffic originating from the LAN interface, or are you aiming to send traffic through the tunnel with the LAN IP as the source?
To better understand and assist you, it would be very helpful if you could share:
- A simple topology of your current setup and desired communication flow (e.g., which devices/networks are trying to reach what through the tunnel).
- Current routing table output (running
route -nin CLI or checking Status → Routes → Static / Dynamic . Note: Make sure to redact any public IPs.
Additionally, there was a similar topic with the AWS S2S VPN topic discussed here: AWS VPN is it posible?, which might be useful to check or bring any insights.
Thank you.
Best regards,