RUTx50 fw 7.11.3 Ipsec - CLI commands & "IPSec Failed to load Data"

[Marcelo.Barros]

Hi…

@aaron451

use the command ipsec status (also tried ipsecstatus

Android 14 VPN IPsec RUTX50 not working

Hello, The error message is likely related to the fact that your device act as the server, and since there is no remote IP, you get this error message. The service, however, should work and this error is not an issue. Perhaps you can share more logs from the IPSec logs that are available from the WebUI? Also, you can access the device via CLI/SSH (username ‘root’) and execute the following command to check IPSec status: ipsec statusall Also, could you please share your IPSec configurations f…

Can you try…

root@device:/etc# ipsec statusall
Status of IKE charon daemon (strongSwan 5.9.6, Linux 5.15.149, mips):
uptime: 29 minutes, since May 28 10:49:50 2024