RUT200 Port forwarding issue, Can't access NVR

Networking Solutions
1

Hello,

Port forwarding issue, Can’t access NVR.
Not shure port forwarding or Firewall configuration issue?

LinasSin

3

Hello LinasSin,

Thank you for your message.

Please refer to the following guide for detailed instructions on configuring camera access through VPN:

To summarize, make sure you complete these steps:

  1. Set up the VPN tunnel – configure and ensure it is active.
  2. Verify LAN & camera connectivity – confirm the camera is accessible locally.
  3. Adjust firewall settings – allow VPN traffic to reach the camera’s IP/port.
  4. Route VPN traffic correctly – enable forwarding from the VPN zone to LAN.
  5. Test remote access – connect via VPN and attempt to reach the camera.

If the issue persists after following these steps, we may need to carry out deeper troubleshooting to identify the cause.

Kind regards,
V.

4

This topic was automatically closed after 60 days. New replies are no longer allowed.