Router TRB142. AT+QCSQ=0

NETWORKING SOLUTIONS
1

I got remote access (getting control in a Teams session) to a Router TRB142 Firmware: TRB1_R_00.07.04.2. Kernel: 5.4.229. Configured: Serial type modem and full control.
The Router is continuously sending messages to serial port:
+QCSQ: “LTE”,49,-78,238,-8
+QCSQ: “LTE”,49,-78,238,-8
I know that AT+QCSQ=0 is disabling these messages, but I didn’t test if I will have to send this AT command again after a Router reset. Do I have to send this command after every Router reset/reboot or it is stored in NVM?

Regards

2

This topic was automatically closed after 15 days. New replies are no longer allowed.