DOUT1 in FMC125 continuously lit within an overspeed zone

[Mathiu]

Hello everyone, I have the following scenario: I have a Manual zone with speed control.

The idea is that, as long as I remain in the zone and above the speed limit, Digital Output 1 DOUT1 should never turn off.

I tried setting the value of DOUT1 ON = 0, but it won’t let me because the minimum is 100.

My question is, is there any way that if the speed is not reduced and it is activated, the digital output will always remain on and not depend on the value of the DOUT1 ON field?

Thank you.

[laith.sa]

Hello @Mathiu

it can be done through CDP,

usualy we make this logic (ON/OFF) for a safty recpective,

[Mathiu]

Hello Laith.sa! Thank you for your reply.

What do you call it, or tell me what a CDP would be?

What I need is for DOUT1 to remain active, without timing, within that range and at that speed.

And today I have DOUT1 ON = 5000 (5 seconds).

Thank you very much.

[laith.sa]

hello

in the CDP, our developer will do a special development on the FW to meet your requirement,

you can contact the sales manager or open VIP case to do so,

[Mathiu]

Oh, okay, perfect. I didn’t know that.

I’ll contact my Teltonika representative to explain the situation.

Thank you very much.