# Modbus TCP on a EVC12 - is it possible?

**URL:** <https://community.teltonika.lt/t/modbus-tcp-on-a-evc12-is-it-possible/21834>\
**Category:** Question\
**Created:** [November 3, 2026, 5:27pm UTC](https://community.teltonika.lt/t/modbus-tcp-on-a-evc12-is-it-possible/21834 "2026-11-03T17:27:41Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![npinto](https://community.teltonika.lt/user_avatar/community.teltonika.lt/npinto/32/26815_2.png) [@npinto](https://community.teltonika.lt/u/npinto)\
**Post date:** [November 3, 2026, 5:27pm UTC](https://community.teltonika.lt/t/modbus-tcp-on-a-evc12-is-it-possible/21834/1 "2026-11-03T17:27:41Z")

</div>

Hi,

Recently an installer installed an EVC12 in my garage - mistakenly, as I was expecting it to be an EVC2x and had a load manager prepared to handle Modbus TCP.

In the EVC12 I see Load Management only via Modbus RTU; is it at all possible to enable Modbus TCP?

Thanks in advance,

Nuno

---

<div class="post-metadata">

**Author:** ![Dziugas-Teltonika](https://community.teltonika.lt/letter_avatar_proxy/v4/letter/d/97f17d/32.png) [@Dziugas-Teltonika](https://community.teltonika.lt/u/Dziugas-Teltonika)\
**Post date:** [November 4, 2026, 7:19am UTC](https://community.teltonika.lt/t/modbus-tcp-on-a-evc12-is-it-possible/21834/2 "2026-11-04T07:19:14Z")

</div>

Hi,

Unfortunately, **Modbus TCP is not supported on the EVC12**. The EVC12 only supports **Load Management via Modbus RTU (RS485)**, and there is currently no option to enable Modbus TCP through settings or a firmware update.

If your EMS or load management system requires Modbus TCP, you would need to use a **Modbus TCP-to-RTU gateway** (provided your controller supports this setup) or consider replacing the charger with an **EVC2/EVC2x** , which supports Modbus TCP communication.

So, if your installation was designed around direct Modbus TCP integration, the EVC12 will not be able to provide that functionality natively.

Kindest regards,  
Džiugas-Teltonika

---

<div class="post-metadata">

**Author:** ![npinto](https://community.teltonika.lt/user_avatar/community.teltonika.lt/npinto/32/26815_2.png) [@npinto](https://community.teltonika.lt/u/npinto)\
**Post date:** [November 4, 2026, 11:32pm UTC](https://community.teltonika.lt/t/modbus-tcp-on-a-evc12-is-it-possible/21834/3 "2026-11-04T23:32:58Z")

</div>

Hi,

Thank you for your swift reply. I will then go for a TCP-to-RTU gateway to set it all in place.

Thanks again,

Nuno
