Ever since upgrading from R_00.07.08.2 to R_00.07.09.0 on my RUTX50 and RUTC50, I am having an issue with shared network interfaces. I only noticed yesterday as I was setting up the RUTC50.
To explain:
From day 1 I had 2 wireless WAN client connections on the RUTX50 (failover):1x Multi AP and 1x Ziggo (the latter due to WPA2-EAP that cannot be handled through the Multi AP settings yet) and both would be connecting through wwan (as virtual WAN interface using DHCP).
The error I get is:
Has something changed in the settings that require another approach for this (I’m inclined to think it’s me), or did I actually run into a snag on the firmware? So far I tried all firmware updates up to R_00.07.10 and back, but no luck.
I have been searching pretty much everywhere, but for the life of me I cannot figure it out.
If the approach/setup has changed, could someone elaborate, or perhaps point me in the direction of the correct documentation please?