FMC920 Stop mode

Hi,

it seems device gets into stop mode after some substantial delay.

I have enabled System > Movement Source > Ignition and Accelerometer.

I’m tracking device and events on Traccar server (by TCP over GPRS) and by SMS.

When I park my car and turn off ignition I’m getting immediate notification (by both tcp server and sms) that Ignition is Off (which is correct).

However I’m getting notified that vehicle has stopped (over tcp server) only after 20 minutes or more that an hour.

Is this expected behavior? What configuration affects stop status? Is there a way to see in Teltonika Configurator if vehicle is considered in Stop Mode?

Thanks for any hints!

p.s. I’m trying to troubleshoot what seems to be excessive battery usage and I think this Stop mode may be affecting it.

edit: FW version: 04.00.00 Rev:14 Configurator: 1.8.10_B.4.00_R.7

Hi,

Thanks for writing to us.

To ensure the device enters sleep mode correctly, certain conditions must be met. I recommend using Ignition source as (DIN 1) or Power Voltage and the movement source as ignition and configuring the required timeout under the Sleep settings. From Data acquisition settings set the stop timeout should be longer than the server’s Open Link Timeout, and the Send Period should be at least 90 seconds shorter than the Open Link Timeout. This allows the device to close the network connection.

Please refer to the link below for more details, as several conditions must be met for the device to enter sleep mode correctly.

You can verify the sleep status through the GNSS Info tab in the device configurator or by using the getinfo SMS command.