Ask a question

479 questions

598 answers

756 comments

448 members

Ask a question
0 votes
42 views
asked in Networking by
Is it possible for the RUT955 to monitor the incoming power and cut if off when it reaches a certain level?
It is possible for the RUT850 and I was hoping for the same feature in the RUT955.

1 Answer

0 votes
answered by

Hello,

Sleep mode functionality is only available in RUT850 routers.

If you need to turn off router at certain voltage levels, try to use analog input to measure router input voltage and configure a rule, which will change relay state from ON to OFF. If you wire power line through relay, this will cut the voltage and router will turn OFF. However, this solution only works if you need to turn OFF the router. To turn it ON again, you will need additional circuit, which can hold router ON long enough, until i/o service will be activated and relay will change state to ON.

All information about RUT955 Input/Ouput functionality is located in Teltonika wiki: https://wiki.teltonika.lt/view/RUT955_Input/Output 

commented by
Thanks for the info. I'm thinking of cutting the power via an external mechanism, what would the downsides be?
commented by
Can't say, but everything has to be alright, we haven't see any issues, if router is turned off with cutting off power.